This 1911 rail mount adapter is deceptively simple. The mount itself is made of a black Delrin plastic and is formed with extremely clean lines and sharp corners. It is designed to snap around the front dustcover portion of the pistol’s receiver. The right side of the mount is longer than the left side, and has a hole drilled to correspond to the location of the slide stop pin.
The 1911 package includes a special slide stop that is slightly longer than a standard 1911 slide stop, and has the end of the pin finished flat rather than rounded. All that’s required to install this accessory rail is to remove the standard slide stop, snap the rail in place, and install the matching slide stop.
** This adapter may not fit Rock Island products
This allows you to attach one of our rail mount Red or Greed lasers, rail mount flashlights or other rail mount accessories. They all fit this rail mount perfectly!
Its so tough, the 1911 rail adapter has been tested and approved by:
- Colt
- M1911.org
- Navy Seals
- US Special Forces
- Military Police
Colt had 27 certified shooters send thousands of rounds down range! Their only comments were: “after 565 rounds, you may need to tighten the little teflon screw a half turn.”
Will stay solidly attached to your weapon
- Maintains bore-sight
- Slips onto your weapon
- It will NOT mark or scratch your guns finish because its constructed from Delrin plastic. Delrin offers an excellent balance of properties that bridge the gap between metals and plastics.
Low moisture absorption – Delrin can operate in wet environments with little effect on performance or dimensions due to:
- High fatigue endurance
- High strength and stiffness properties
- Superior impact and creep resistance
- Good wear and abrasion properties
Manufactures warranty: One year against manufacture defects.
Click here to watch a one minute video on how easy this adapter is to install.
Click here to view the installation instructions
This rail mount adapter is designed for 1911’s and made in the United States of America.
